Saturday, 7 January 2012

Pairing a Lemond Power Pilot with a Garmin Speed / Cadence Sensor GSC 10

This post describes what you need in order to pair your Lemond Power Pilot with the Garmin Speed / Cadence Sensor and what needs to be done in order to get it working.

What do you need:

  • The obvious:
    • Lemond Power Pilot
    • Garmin Speed/Cadence sensor GSC 10
  • The not so obvious:
    • Power Pilot Firmware - version 63 ==> This version allows the power pilot to use speed/cadence combo sensors (only the Cadence will be used)

What needs to be done:

  1. Check the firmware version of the Power Pilot and upgrade if necessary – Howto can be found here http://starttotriatlon.blogspot.com/2012/01/how-to-upgrade-firmware-of-your-lemond.html including the link to the latest firmware.
  2. To enter Pairing Mode press and hold the DIST/SPEED and STOP buttons for three (3) seconds                                            image
  3. Press the HR/KCAL button. “Pair” will blink on the display until pairing is complete.                                                       image  Note: Both sensors must have been active within the last twenty (20) minutes in order to pair. Pedal to activate sensors.
  4. If pairing is successful, the display will show the ID codes of both sensors:            image
  5. Your Garmin Speed / Cadence sensor GSC 10 is now successfully connected to your Lemond Revolution Power Pilot

If you find this blog post useful please be so kind to click on an AD.

Greetings,

Gert

1 comment: